PT. MIMAKI INDONESIA

What system configuration do I need?

  • The following is the basic system configuration.

- Data is sent from your PC for data creation (client PC) to the PC with RIP software "RasterLink6"
 installed (RIP PC) via a network.

- RIP software "RasterLink6" is attached to the main unit.
In addition to UJF-7151plus main unit, RIP PC and USB 2.0 or LAN*1 cable are required.

About the PC specifications for RIP, see the operating environment for “RasterLink6”.

*1 If you print via LAN cables, you need to configure your network with the following environment.
- Use LAN cables that are category 6 or higher.
- Use PC that supports 1000BASE-T.
- If you use a hub, use a switching hub that supports 1000BASE-T.


Return to Content

PAGETOP